Name: SOMMER TQ-S Tracer
Brand: SOMMER
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Sommer GmbH 28

7.6. Post processing

In some cases it makes sense to post process the measured data for correction of e.g. fluctuating base

values.

Choose a data set by selecting Data (F10)



Measurement.

Then choose the tab Measurement on the right side, which will make a set of tools available:

Calculation begin

In following situation the measurement was started too early (the position of a the sensor had been

changed, which caused the downward peak):

Questions and Answers:

Need help?

Do you have a question about the SOMMER TQ-S Tracer and is the answer not in the manual?

SOMMER TQ-S Tracer Specifications

General