What causes a leaking Water Reservoir on Somnetics Humidifier?
A leaking Water Reservoir on your Somnetics Humidifier could be due to a crack or damage to the reservoir, or the lid might not be correctly attached. Here’s what to check: 1. Ensure the reservoir cover is fully attached to the reservoir base. 2. Inspect the Water Reservoir for any signs of damage or cracks. If you find any damage, no answer.
What does it mean when all three LEDs are flashing on Somnetics Humidifier?
If all three LEDs at the back of your Somnetics Humidifier are flashing, it indicates that the humidifier is in a fault state. To resolve this: 1. Unplug the Humidifier power supply. 2. Wait for 10 seconds. 3. Reattach the power supply to the Humidifier. If the problem continues, no answer.
General| Ramp Time | 0-45 minutes |
|---|---|
| Altitude Adjustment | Automatic |
| Pressure Range | 4-20 cm H2O |
| Humidification | Integrated heated humidifier |
| Power Supply | AC adapter, DC adapter |
| AC Power | 100-240V, 50/60Hz |
| DC Power | 12 VDC |
| Battery Type | Optional external battery |
| Battery Life (with humidifier) | Up to 8 hours |
| Data Recording | pressure data |
Specifies the intended patient population and conditions for therapy.
Lists medical conditions where the device should not be used.
Details potential serious injuries or death to users or others.
Highlights potential minor injuries or equipment damage.
Lists the items included in the standard starter package.
Details the components of the H6B humidification system.
Details the components of the H9M humidification system.
Lists accessories and parts not included in the package.
Overview of the CPAP device's main unit and its control interface.
Describes the power input and data exchange ports on the CPAP device.
Details data slot, air filter, and the patient interface for humidification systems.
Describes the headgear used to secure the CPAP and interface.
Step-by-step guide for assembling the basic Transcend CPAP system.
Instructions for assembling the H6B humidification system.
Instructions for assembling the H9M humidification system.
Guidance on properly fitting the H6B humidification system onto the user.
Guidance on properly fitting the H9M humidification system onto the user.
Instructions for powering the CPAP using the standard AC adapter.
Details on using P4 and P8 battery systems for portable power.
Instructions for powering the CPAP using a mobile 12VDC adapter.
Describes battery status indicators and charging procedures.
Explains Off, Standby, On, and Drying modes of CPAP operation.
Guides on initiating therapy, using the ramp function, and ending a session.
Details the procedure for using drying mode to clear moisture from the device.
Instructions for replacing the CPAP base and forehead pads.
Step-by-step guide for replacing the air inlet filter.
Instructions on how to change the Heat Moisture Exchanger (HME).
Procedures for cleaning the inside of the CPAP device using drying mode.
Procedures for cleaning the outside of the CPAP device.
Guidance on washing and maintaining various CPAP components.
Specific instructions for cleaning the air inlet filter.
Explains fault conditions indicated by the yellow LED flashes.
Describes fault conditions related to smartcard communication.
Details alerts that do not reset the processor during operation.
Explains the reminder for replacing the air inlet filter.
Lists part numbers for disposable items like filters and HMEs.
Lists part numbers for various accessories available for the system.
Lists part numbers for replacement components of the CPAP system.
Details physical dimensions, weight, and connector types for the CPAP.
Lists input/output specifications for AC power supply and mobile adapter.
Provides technical details for the P4 and P8 battery systems.
Outlines performance parameters like pressure range and humidity.
Contains electromagnetic compatibility declarations and guidelines.
To Next Page
