Sonance DSP 2-750 MKII User Manual

10
Advanced Setup Page
This page in SonARC allows you to make advanced changes to
theyouramplierssettingsandconguration.Tostartclickonthe
AdvancedSetupbuttonfromyourMKII’shomepage.
IP Setup
DHCP On/O
DHCPON/OFFistherstoptioninIPSETUP.AllSonanceDSP
seriesampliersshipwithDHCP(DynamicHostConnection
Protocol)ON.InmostinstallationsDHCPshouldbeleftON
except when you are using a control system for IP control. If you
arecontrollingtheDSPseriesamplierusingIP,thenwesuggest
you turn DHCP OFF and use a static IP address.
The basic setup is complete!
NOTE: LEFT AND RIGHT CHANNELS ARE LINKED. OUTPUT VOLUME IS
LINKED TO TURN ON VOLUME IN BASIC SETUP.
Identify Amplier
ID Amp Mode
WhenthepowerswitchisturnedON,thepowerbuttononthe
frontoftheamplierwillashtoindicatewhichamplieryouare
programming.Thiswillmaketheampliereasytoidentifyina
multipleamplierinstallation.
Info
Thisisauserenteredeldwithamaximumof15characters.
Use this area to name your MKII.
General Settings Tab
The Advanced Setup automatically starts out on the General
Settings tab. This tab is used to set up your MKII with a network
network connection, auto on method and other basic information.
Output Settings/Output Volume
Output Name
Thisisauserenteredeldwithamaximumof15characters.
Usetheseeldstodescribetheroomorareathechannelwill
be powering.
IP Address
The second setting in the IP SETUP section is the IP address.
WhenDHCPisONthecurrentIPaddresswillbedisplayed.
To change the IP address DHCP must be set to OFF.
WhenDHCPisturnedotheIPaddressthattherouterassigned
totheamplierwillstillbeapplied.ThisIPaddressisagoodplace
to start since it is not being used by another network device. If you
wish to change the IP address you should perform a scan of the
network and only assign an unused IP address within the range of
your router. As a general rule only change the last three digits of
theIPaddressintheampliersettingsandonlyassignnumbers
between 2 and 254. Following this suggestion will minimize the
chanceofmakingtheamplierinaccessible.
It is critical to type in the correct IP address. If the wrong IP address
isentered,theampliercouldbecomeinaccessible.Makechanges
to the IP settings only if you fully understand network setup.
Resetting DHCP
If the IP address is not known and the amp is locked out, use the
DHCP Reset method in Appendix A.
Output Volume (Basic Set-Up)
Play music with wide dynamics and bass that will stress
the system.
1. Start with the Output Volume for both 1L and 1R set at -30.
2. Slowly increase the volume up towards 12 and listen for
any distortion or strain from the speakers. When you hear any
distortion, reduce the volume 1 or 2 steps below this value.
3. Set this volume number for both channels. This will provide
maximum system performance and protect the speakers from
beingdamagedbyamplierclippingandover-excursionof
the woofers.

Sonance DSP 2-750 MKII Specifications

General

Brand	Sonance
Model	DSP 2-750 MKII
Category	Amplifier
Language	English