Lodestar Hardware
Manual
Document Ref: UM-8084-
Issue: A– Rev
© Sonardyne International Limited 201
5.3 Installation location
The Lodestar can be installed at any convenient location on the vessel, from where
it will deliver accurate measurements. However, to gain optimal performance from
the system, identify a location to install the Lodestar that conforms as closely as
possible to the following criteria:
• If possible, the location should be close to the vessel’s centre of rotation
under normal operating conditions.
• The location must not be subject to excessive vibration or impulse shock.
•
The location must not be subject to strong magnetic or alternating
electrical fields.
• The location must not exceed the environmental limits for temperature
defined in section 4.4 on page 23. Do not subject Lodestar to regular and
rapid changes in temperature.
• The location must provide a mounting surface that is level with respect to
the vessel’s body frame and of sufficient strength to support the Lodestar’s
weight safely and without flexing.
• The location must provide access for p
connections.
• There must be sufficient space to allow easy access to install the
Lodestar, and to connect a PC for configuration purposes.
• Do not store tools, equipment or chemicals where they can damage the
Lodestar or the connection cables.
• Make sure the
Lodestar and its connection cables do not cause an
obstruction to personnel operating in the area. Do not use a location where
the connection
cables are likely to suffer damage from mechanical
stresses or chemical attack.
To Next Page
Loading...