EasyManuals Logo

Sonoscape S22 Pro User Manual

Sonoscape S22 Pro
162 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
6 Acquiring Images
70 Basic User Manual
■  Steer
Steer can be adjusted to change the direction of the acoustic beam when performing a real time scan by using the
linear probes.
To adjust the steer:
Tap the left or right part of
Steer
on the touch screen to change the direction of the acoustic beam.
NOTE:
Only the linear probes are capable of using the steer.
6.3 Acquiring Color Flow Images
Color Flow imaging adds the color-coded qualitative information in the B-Mode image. Color Flow imaging is
helpful to see the ow, the relevant qualitative information and the ow velocity.
6.3.1 CFM Mode
CFM is a color ow imaging technology which adds the color-coded qualitative information concerning the relative
velocity and direction of uid motion in the B-Mode image.
Perform the following steps to acquire CFM-mode images.
1. Optimize a B-mode image.
2. Press the
CFM
key on the control panel to enter the CFM mode.
0
5
10
15
9
-9
cm/s
2D Imaging
Color Flow ROI
B
FPS 47
D/G 3/1
GN 255
I/P 3/30
PWR 70
FRQ 3-4.8
D 16.5cm
C
PRF 1.0
WF 86
GN 255
C/P 1/50
PWR 70
FRQ 2.2
S
Figure 6-6 CFM-Mode Imaging Screen
3. Adjust color ow ROI.
Move the trackball to position color ow ROI.
Press the conrm key on the control panel to adjust the size of color ow ROI.
Press the conrm key again to reposition color ow ROI.
4. Optimize the CFM-mode image. For details, refer to Section 6.4.3 Optimizing M-Mode Images.
5. Press the
CFM
key again to exit the screen.
6.3.2 PDI Mode
PDI (Power Doppler Imaging) is a color ow imaging technology which adds the ow signal in the CFM-mode
image. PDI uses the number and amplitude of red blood cells going through in the flow to create the color-
coded imaging. A ow with slow velocity and small rate can be displayed in PDI. Therefore, a ow with a higher
sensitivity can be detected without overlaying any ows with high velocity.
The direction of ow, the ow velocity and ow properties cannot be reected in the PDI-Mode image.
Perform the following steps to acquire PDI-mode images:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sonoscape S22 Pro and is the answer not in the manual?

Sonoscape S22 Pro Specifications

General IconGeneral
BrandSonoscape
ModelS22 Pro
CategoryMedical Equipment
LanguageEnglish

Related product manuals