Sontex 878 - Mounting the Heat Cost Allocator with Pactan Silicon

42
Instruction for Use | HCA 56x and 8x8
7.7.7 Mounting the heat cost allocator with Pactan Silicon
When using glue for the installation of the heat cost allocators, please refer to the
EN 834.

Clean the aluminium back plate with a absorbent cotton pad soaked in acetone.

Clean the gluing place on the radiator with a absorbent cotton soaked in acetone.

Assemble the heat cost allocator and the aluminum back plate. Put the seal on.

Apply Pactan glue to the 2 rails of the aluminum back plate.

Press the the heat cost allocator against the radiator in the desired position, and allow the
glue to disperse evenly.

Press firmly and align the heat cost allocator. Wait 2-3 minutes and check that it is aligned
straight. It should stand on its own. After 10 hours, the heat cost allocator will be well
bonded to the radiator.

Remove excess glue with a screwdriver, clean the radiator with paper towels.
Removing the adhesive from the distributors

Remove the aluminum back plate with a size 2 screwdriver and a hammer. Place the screw
driver in the groove of the aluminum rail and tap with the hammer on the screwdriver until
the aluminum plate is removed.

With a carpet knife, remove any remaining glue and then clean with acetone.