2-1
BKM-120D/127W/129X/142HD
Section 2
Electrical Adjustments
2-1. Preparations For BW Board
Adjustments (BKM-127W)
Set as follows in the INPUT CONFIGURATION menu of
the menu.
..
..
. 01 CH
FORMAT ..................NTSC, PAL
SLOT NO. ................. SLOT 1
INPUT NO. ...............1
COLOR TEMP ......... STD
APERTURE ..............100
H PHASE .................. 000
NTSC SETUP ........... 0
VCR MODE.............. OFF
..
..
. 02 CH
FORMAT ..................NTSC, PAL
SLOT NO. ................. SLOT 1
INPUT NO. ...............2
Same as 01 CH for others
..
..
. 04 CH
FORMAT ..................NTSC, PAL
SLOT NO. ................. SLOT 1
INPUT NO. ...............3
Same as 01 CH for others
..
..
. 05 CH
FORMAT ..................NTSC, PAL
Same as 04 CH for others
The BKM-127W is an optional board for the BVM series,
(BVM-D9H1/D9H5/D14H1/D14H5), and therefore will
not operate on its own. To adjust and measure it, BKM-
127W must be mounted with a BVM series monitor. The
BKM series monitor used in these adjustments should
satisfy the respective specifications.
[Preparations]
..
..
. Required tools and measuring instruments
1. Signal generator
YPBYPR signal generator
..
..
. 1080/60i (1125) : SMPTE274M standard/
BTA S-001 standard
..
..
. 1035/60i (1125) : BTA S-001 standard or
SMPTE240M standard
..
..
. 720/60p : SMPTE296M standard
..
..
. 480/60p (525p) : BTA T-1004 standard or
SMPTE293M standard
..
..
. 480/60i (525) : ITU601
..
..
. 1080/48i (1125) : —
..
..
. 1080/50i (1125) : SMPTE274M standard
..
..
. 720/50p : —
..
..
. 575/50p (625p) : —
..
..
. 575/50i (625) : ITU601
NTSC analog composite signal generator
HD SDI signal generator
D1 SDI signal generator
2. BKM-127W (NTSC/PAL input adapter)
3. BKM-142HD (HD SDI input adapter)
4. BKM-120D (D1 SDI input adapter)
5. Oscilloscope
To Next Page
