Inserting Batteries into the Remote Control
Insert two size AA batteries (supplied) by
matching O and • on the batteries to the
diagram inside the battery compartment of
the remote control.
Initial Setup
The Initial Setup screen appears when you turn on the TV for the first time.
During this initial setup, you can perform the following:
1 Select the language for the on-screen display text.
2 Select HOME or Retail mode.
3 Connect cable or antenna, then select OK to run Auto
Program.
• If you have cable and antenna available, please connect
cable first.
4
IMPORTANT: Auto Program process is only effective when cable or antenna is connected.
If you cancel Auto Program before completion some channels may not be available.
Auto Program will scan for available channels from the signal source directly connected to
the TV's CABLE/ANTENNA input and may take sometime to complete the process. Follow
the help text provided on the screen to run Auto Program.
_" Suggesdons
12
To Next Page
Loading...
Need help?
General