Sony BVS-3100P - Page 31

"DME-450P auto setup”
"KEY" operations are executed on the
BVS-3000 Series switcher side when
DME-450P patterns are executed from
that switcher. For this reason,
SOURCE/
FILL/KEY-ON,
etc.,
are
set
automatically
when
DME
patterns
are
selected.
The
setting
parameter
at
this
time
can
be freely selected.
The
parameter
specifies
whether
KEY
ON
is
to
be
automatically
executed
when
KEY-1/KEY-2/DSK/KEY-SOURCE/KEY-FILL
and
DME patterns are selected.
@ set "STATUS" to 301.
®
Decide
which
"KEY"
processor
will
execute
DME
patterns.
@
Set
the
switches/LEDs
for
SOURCE/
FILL/KEY-1/
(KEY-2/DISK)
/KEY-ON
(DISK-ON).
If
the
user
does
not
plan
to
set
the
KEY-ON
(DSK-ON)
LED,
only
the
SOURCE/FILL
setting
is
needed.
@®)
Press
the
"CUT"
switch.
(Setting
complete.)
Note:
When
making
the
"KEY-ON"
setting
during
auto
setup,
the
"TITLE"
mode
of
DME-450P
patterns
can
be
"ON"
by
turning
the
KEY
"CLIP"
knob
fully
counterclockwise,
or
"OFF"
by
full
In
any
case,
normal
turned
turning it
clockwise.
effects
can
be
obtained
with
the
CLIP"
knob
in
the
center
position.
BVS-3100P (EK)
3-3
(6)
"status"
The five
possible for BVS-3000 Series switchers
types of operational status
can be displayed in this mode.
"POWER unit emergency"
If status is normal, the LED display
reads 600 when set to 6x0.
If there is a malfunction (an abnormal
rise in temperature) of the power
supply unit in the processor of the
BVS-3000 Series switcher, the LED
display will read 610 and a buzzer will
sound continuously.
the
if this display appears.
Be sure to turn
n OFF n
quickly power
switch
“memory backup"
If status is normal, the LED display
reads 601 when set to 6xl.
If the "SNAP SHOT" memory backup power
supply voltage level in the processor
of the BVS-3000 Series switcher drops
and the data held in memory
the LED display will read 611.
All BVvS-3000 Series
capacitor of high-storage capacity as a
is lost,
switchers use a
backup power supply and data can be
stored for 3 to 4 weeks on a 4 hour
charge. The capacitor is charged while
the BVS-3000 Series switcher power is
"ON".
The the
automatically writes data corresponding
microcomputer in processor
to the initial settings to the capacitor
if the data held in memory is lost.