2-3
MVS-8000 System
SYSTEM SETUP
3. Attach the right and left brackets to the rack complete-
ly using the specified eight screws.
(The illustration below shows the left bracket.)
4. Tighten the screws (four screws each on the right and
left) for adjusting the length of the bracket completely
(the screws that were loosened in step 2).
5. Remove the front panel.
6. Remove the 16 screws and remove the handles (two
handles each on the right and left) from both sides of
the MVS-8000.
B4 x 10
31.75
Front side
Bracket
Rack
B4 x 10
31.75
Rear side
Bracket
Rack
RK5 x 10
RK5 x 10
RK5 x 10
RK5 x 10
Handle
Handle
Handle
Handle
2-2. MVS-8000 Installation
Unit : mm
7.
Place the right and left bottom ends of the MVS-8000 on
the support angles, and slide the equipment to the rear.
n
The support angles support the equipment as shown below.
8. Fix the rack angles of the equipment to the rack using
the specified eight screws.
9. Attach the front panel to the equipment.
Support angles
Bracket Bracket
B5 x 12
B5 x 12
Rack
Rack angle
Rack angle
To Next Page
Loading...
