Sony CCP-8000 - Ethernet Switch Settings

3-5
MVS-8000 System
SYSTEM SETUP
3-4. Ethernet Switch Settings
3-4. Ethernet Switch Settings
The following Ethernet switches are tested to MVS-8000 system.
Recommended models
Vendor Model name
Cisco Catalyst 29xx-XL
Cisco Catalyst 35xx-XL
Cisco Catalyst 4000 series
Cisco Catalyst 5000 series
* : Please confirm the details of a recommendation model 1 to a Cisco agency.
The Ethernet switch for MVS-8000 system requires the following settings
Follow the flowchart below to setup Ethernet switch.
1. Initialize Ethernet switch
(Required minimum settings)
2. Set VLAN
(Depending on the customer’s system situation)
Procedure of setup ethernet switch
Start
Ethernet switch
Initial setting
IP Address setting
etc
Disable CDP
More than
one LAN are connected
to one Ethernet
switch
VLAN setting
VLAN setting
Disable
Spanning Tree
Disable
Spanning Tree
Yes
No
End
Disable CDP
Disable VTP
Assign Sc0
to VLAN
IP Address setting
C4000/5000 series
C29xx-XL/35xx-XL series