3-6
MVS-8000 System
SYSTEM SETUP
3-4. Ethernet Switch Settings
A) Initialize ethernet switch
Cisco Catalyst 29xx-XL series or Cisco Catalyst 35xx-XL series require the following parameters to
initialize.
For details, refer to Quick Start Guide supplied with a Ethernet switch
n
If the following network configuration does not fit your existing Ethernet configuration, make sure all
nodes have unique node address and are place on the appropriate network.
IP address 10.4.17.254
*1
Subnet mask 255.0.0.0
Default gateway Not used
Host name CiscoSW1
*2
Secret password ciscosw1 (host name in small letters)
*2
Telnet password ciscosw1 (same as secret password)
*2
Cluster command switch Not used
*1 : On Second and later Ethernet switch, simply subtract 1 to the node address. For example, the second Ethernet switch would have
an address of 10.4.17.253.
*2 : On Second and later Ethernet switch, simply add 1 to the number of the host name. For example, the second Ethernet switch would
have a host name of CiscoSW2.
In case of Cisco Catalyst 4000 series or Cisco Catalyst 5000 series
Cisco Catalyst 4000 series or Cisco Catalyst 5000 series requires initializing and setting VLAN together.
Step the next procedure “B) Set VLAN”.
To Next Page
Loading...
