3-8
MVS-8000 System
SYSTEM SETUP
3-4. Ethernet Switch Settings
In Case of Cisco Catalyst 4000 Series or Cisco Catalyst 5000 Series
The settings require Cisco Command Line Interface (CLI).
For details of operation, refer to Family Software Configuration Guide of Catalyst 4000 series or Cisco
Catalyst 5000 series.
The required parameters for MVS-8000 system are follows.
There are two interfaces to setup IP address in Catalyst 4000 series.
They are called sc0 and mel.
The sc0 port is normal Ethernet port.
The switch can be accessed and set by setting IP address to sc0 and connecting a PC to any of normal
Ethernet ports.
The mel port is 10 BASE-T port on supervisor engine.
The switch can be set by connecting a PC to this port.
Step 1 : IP Address
Both IP address “sc0” and “mel” are required.
The network segment of the sc0 and mel ports is recommended to be separated.
Example
sc0 me1
IP Address 10.4.17.254 192.168.0.254
Subnet Mask 255.0.0.0 255.255.255.0
Step 2 : Disable VTP
Disable VTP as Catalyst 4000/5000 Family Software Configuration Guide.
Connect PC to a node of Ethernet switch with Ethernet cable.
Browser requires to setup as Quick Start Guide.
1) Access the Ethernet switch via personal computer.
2) Open Cluster Management Suite of the switch.
Step 3 : Set VLAN
The separated VLAN settings are required to control LAN, data LAN, and peripheral LAN.
They require more than 3 VLAN setting.
Name VLAN for each network.
Assign port as system setting to named VLAN.
Example of C4003 96 port
controlLAN 1 Port 1 to 12
controlLAN2 Port 13 to 14
dataLAN1 Port 25 to 36
dataLAN2 Port 37 to 48
peripheralLAN1 Port 49 to 60
peripheralLAN2 Port 61 to 72
managementLAN1 Port 73 to 84
managementLAN2 Port 85 to 96
The managementLAN 1/2 manage Ethernet switch and system with the above setting.
To Next Page
Loading...
