3-13
MVS-8000 System
SYSTEM SETUP
Setting items
System
11
11
1 System
22
22
2 System
33
33
3
Device SWR1/SWR2 SWR1/SWR2 SWR1/SWR2
Matrix Size Standard Standard Standard/Compact
Setting Setting Setting
Source
*
: 1 Source
*
: 1 Source
*
: 1 to Max (889 (S), 897 (C))
Destination
*
:1 Destination
*
:1 Destination
*
: 1 to Max (887 (S), 897 (C))
Level : 1 Level : 1 Level : 1 to 8
* : Set the top value of matrix for both of the Source and Destination. The end value is determined automatically in accordance with the
Matrix Size.
As to the Source Address, the same Source Address can be duplicated and be set using SWR1/SWR2.
The value with parenthesis (S) is the value when Standard mode is selected. The value with parenthesis (C) is the value when
Compact mode is selected.
For the system
11
11
1
Select “Standard” that is the default setup of Matrix Size for the system 1.
Default setup :
Matrix Size : standard (136 x 138)
For the system
22
22
2
Select “Standard” that is the default setup of Matrix Size for the system 2.
Default setup :
Matrix Size : standard (136 x 138)
For the system
33
33
3
Select either “Standard” or “Compact” of Matrix Size depending on the number of units of the equipment
consisting the system.
When “Standard” (136 x 138) is selected, the switcher is assigned to the S-Bus space with the full size.
(All of the inputs and outputs of the switcher can be assigned to the S-Bus space.)
When “Compact” (128 x 128) is selected, the switcher is assigned to the S-Bus space with the compact
size.
(Not all of the inputs and outputs of the switcher are assigned to the S-Bus space, but the S-Bus space can
be effectively used.)
n
If two units of the MVS-8000 switcher processor are connected, each switcher processor must be set
independently. Select the target device to be set using “Device” of this menu. Assign each switcher
processor to SWR1/SWR2 using the menu screen (Engineering Setup → System → Network Config).
3-7. Tally Setup
To Next Page
Loading...
