3-25
MVS-8000 System
SYSTEM SETUP
Setting items
System
11
11
1 System
22
22
2 System
33
33
3
Tally Gp Gp1-4/Gp5-8 Gp1-4/Gp5-8 Gp1-4/Gp5-8
SBus Tally Enable Disable Disable Enable/Disable
For the system
11
11
1
Select “Gp1-4” or “Gp5-8” as desired from the Tally Group for the system 1. As to the S-Bus Tally,
select “Disable” (i.e., the “SBus Tally Enable” button is not selected) because there is no equipment that
is connected by S-Bus.
For the system
22
22
2
This setting is not required for the system 2 because the system 2 does not use tally. Select either
“Gp1-4” or “Gp5-8” from the Tally Group for the system 2. As to the S-Bus Tally, select “Disable”
because UMD is not connected to the system 2.
For the system
33
33
3
Select “Gp1-4” or “Gp5-8” as desired from the Tally Group for the system 3. As to the S-Bus Tally,
select “Enable” (i.e., select the “SBus Tally Enable” button) if there is any equipment (such as UMD) that
is connected by S-Bus.
3-7. Tally Setup
To Next Page
Loading...
