3-33
MVS-8000 System
SYSTEM SETUP
Setting items
System
11
11
1 System
22
22
2 System
33
33
3
Tally Copy Setting is required Setting is not required Setting is required
For the system
11
11
1
Set the virtual terminal number of copy source (From Source) and copy destination (To Source) as
required.
For the system
22
22
2
Because there is no equipment that is connected on matrix in this system, this setting is not necessary.
For the system
33
33
3
Set the virtual terminal number of copy source (From Source) and copy destination (To Source) as
required.
Setup example : For the system
33
33
3
System: MVS-8000 x 1 unit, router x 1 unit (8 x 4)
1. Connect the video signal (with TC) from VTR to Primary 8 (virtual terminal No. 26) of the switcher.
2. Connect the video signal (without TC) from VTR to Primary 7 (virtual terminal No. 25) of the
switcher.
Establish the Tally Copy setup because the tally information must be output after the tally informations
from the two sources are unified to a single tally information.
Page 7365
Copy# From Source To Source
1 26 SWR8 25 SWR7
3-7. Tally Setup
To Next Page
Loading...
