Sony CDP-C701ES - Handling and Checking Procedures; Optical Pick-up Block Handling; Laser Diode Emission Check; Transit Key and Red Lock Screw Usage

For the European Countries
Notes on the Transit Key
Elite Ml at=re Mm Mele @olegs
This appliance is classified as
CLASS 1 LASER PRODUCT a CLASS 1 LASER Product.
LUOKAN 1 LASERLAITE The CLASS 1 LASER
KLASS 1 LASERAPPARAT PRODUCT MARKING is
Note
This appliance conforms with EEC Directive 87/308/EEC regarding
interference suppression.
The following caution label is located inside the unit.
CAUTION : INVISIBLE LASER RADIATION WHEN OPEN,
AVOID EXPOSURE TO BEAM.
ADVARSEL: USYNLIG LASERSTRALING VED ABNING NAR
SIKKERHEADSAFBRYDERE ER UDE AF FUNKTION.
UNDGA UDS AETTELSE FOR STRALING.
VARO! . AVATTAESSA JA SUOJALUKITUS OHITETTAESSA
DLET ALTTIINA LASERSATEILYLLE.
VARNING : LASERSTRALING NAR DENNA DEL AR OPPNAD
OCH SPARREN AR URXOPPLAD.
ADVERSEL: USYNLIG LASERSTRALING NAR DEKSEL APNES
UNNGA EKSPONERING FOR STRALEN.
NOTES ON HANDLING THE OPTICAL PICK-UP
The laser diode in the optical pick-up block may suffer
electrostatic breakdown because of the potential di-
ference generated by the charged electrostatic load,
etc. on clothing and the human body.
During repair, pay attention to electrostatic break-
down and also use the procedure in the printed matter
which is included in the repair parts.
The flexible board is easily damaged and should be
handled with care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to
be focused on the disc reflective surface by the objec-
tive lens in the optical pick-up block. Therefore, when
checking the laser diode emission, observe from more
than 30cm away from the objective lens.
located on the rear exterior.
CDP-C801ES only)
a) Transit key
The transit key on the bottom of the
player protects the optical system
against shock during transportation.
Before operating the player, be sure to
remove the key by following the
instructions on the label, and keep it in a
safe place.
When transporting the player, re-install
the key by following the instructions
below.
1 Remove all the discs from the player.
2 Press & to close the disc tray and
wait for“ 9 (or 7, % ...)’ to
disappear in the display.
3 Turn the power off.
4 Insert the key into its original hole and
lock it in place.
b) Red lock screw (CDP-C801ES only)
Besides the transit key, the
CDP-C801ES has a red lock screw on
the bottom. Before operating the CDP-
C801ES, be sure to remove the transit
key and red lock screw, and keep them
in a safe place.
When transporting the player, re-install
the screw and key by following the
instructions below.
1 Remove all the discs from the player.
2 Press DISC SKIP until the DISC 1
compartment is at the front position.
3 Press & to close the disc tray and
wait for “ 17” to disappear in the
display.
4 Turn the power off.
5 Re-install the red lock screw and
transit key.