5
CFD-E75
SECTION 2
GENERAL
This section is extracted from
instruction manual.
4
Connect the supplied AC power cord (see page 24).
1
Press ZPUSH OPEN/CLOSE down
to open the CD compartment and
place the CD on the CD
compartment.
2
Close the lid of the CD compartment.
3
Press u (N on the remote).
The player turns on (direct power-on)
and plays all the tracks once.
Basic Operations
3
Playing a CD
Display
With the label side up
1, 2
PUSH OPEN/CLOSE
PUSH OPEN/CLOSE
Playing timeTrack number
Basic Operations
5
Use these buttons for additional operations
POWER
x
u
Jog dial
VOLUME +, —
ZPUSH
OPEN/CLOSE
To Do this
adjust the volume Press VOLUME +, — (VOL +, — on
the remote).
stop playback Press x.
pause playback Press u (X on the remote).
Press the button again to resume
play after pause.
go to the next track Turn the jog dial clockwise.
(On the remote, press >.)
go back to the previous track Turn the jog dial counterclockwise.
(On the remote, press ..)
remove the CD Press ZPUSH OPEN/CLOSE.
turn on/off the player Press POWER.
About CD-Rs/CD-RWs
This player is compatible with CD-Rs/CD-RWs but
playback capability may vary depending on the quality of
the disc, the recording device and application software.
6
Listening to the radio
Connect the supplied AC power cord (see page 24).
1 Press RADIO BAND¥AUTO
PRESET until the band you want
appears in the display (direct power-
on).
2 Hold down TUNE + or — until the
frequency digits begin to change in
the display.
The player automatically scans the
radio frequencies and stops when it
finds a clear station.
If you can't tune in a station, press
the button repeatedly to change the
frequency step by step.
Display
Indicates an FM stereo
broadcast
12
RADIO
AUTO PRESET
BAND
T
U
N
E
Basic Operations
7
Use these buttons for additional operations
To Press
adjust the volume VOLUME +, —
(VOL +, — on the remote)
turn on/off the radio POWER
To improve broadcast reception
Reorient the antenna for FM. Reorient the player itself for
AM.
for FM for AM
Tip
If the FM broadcast is
noisy, press MODE until
Mono appears in the
display and the radio will
play in monaural.
POWER
VOLUME +, —
MODE
To Next Page
Loading...
