Sony CFD-E75 - Playing a Tape; Recording on a Tape

6
CFD-E75
8
Playing a tape
Connect the supplied AC power cord (see page 24).
1 Press xZ to open the tape
compartment and insert a recorded
tape. Use TYPE I (normal) tape only.
Close the compartment.
2 Press n.
The player turns on (direct power-on)
and starts playing.
With the side you want
to play facing you
Display
21
Basic Operations
9
Use these buttons for additional operations
To Press
adjust the volume VOLUME +, —
(VOL +, — on the remote)
stop playback xZ
fast-forward or rewind the tape m or M
pause playback X
Press the button again to
resume play after pause.
eject the cassette xZ
turn on/off the player POWER
xZ
X
m, M
POWER
VOLUME +, —
10
Recording on a tape
Connect the supplied AC power cord (see page 24).
1 Press xZ to open the tape
compartment and insert a blank tape.
Use TYPE I (normal) tape only.
2 Select the program source you want
to record.
To record from the CD player, insert
a CD (see page 4) and press x on the
CD section.
To record from the radio, tune in the
station you want (see page 6).
3
With the side you want to
record on facing you
Display
1
RADIO
AUTO PRESET
BAND
Basic Operations
11
3 Press z to start recording
(n is depressed automatically).
Use these buttons for additional operations
Tips
¥ Adjusting the volume or the
audio emphasis (see page
18) will not affect the
recording level.
¥ If the AM program makes a
whistling sound after you've
pressed z in step 3, press
MODE to select the
position of ISS
(Interference Suppress
Switch) that decreases the
noise the most.
¥ For the best results, use the
AC power as a power
source.
¥ To erase a recording,
proceed as follows:
1 Insert the tape whose
recording you want to
erase.
2 Press X.
3 Press n.
4 Press z.
5 Press X.
xZ
X
POWER
MODE
n
To Press
stop recording xZ
pause recording X
Press the button again to resume
recording.
turn on/off the player POWER