Timer/Display
49
GB
Other operations
Notes
• If you use the Play Timer and the Sleep Timer at the
same time, the Sleep Timer has priority.
• The system turns on 30 seconds before the preset
time. Do not operate the system from the time the
system turns on until the play starts.
• The Play Timer will not be activated when the
following occurs 30 seconds before the preset time.
– The system is turned on.
– “STANDBY” is blinking in the display.
• You cannot use the optional component connected to
VIDEO/SAT IN L/R jacks as the sound source for
Play Timer.
The demonstration display (display window and
buttons lighting and flashing even when the
system power is off) and the clock display can
be turned off to minimize the amount of power
consumed during standby (Power Saving
Mode).
Press DISPLAY repeatedly while the
system is off until the demonstration
display or the clock display disappears.
To cancel Power Saving Mode
Press DISPLAY while the system is off. Each
time you press the button, the display switches
cyclically as follows:
Demonstration display t Clock display* t
No display (Power Saving Mode)
* “– –:– –” appears if you have not set the clock.
Tips
• The timer continues to operate in Power Saving
Mode.
•
?/1 indicator lights up even in Power Saving Mode.
Press DIMMER on the unit repeatedly to
turn the display on or off while the system
is on.
Each time you press the button, the display
changes as follows:
DIMMER OFF y DIMMER ON
To Do this
Check the setting 1 Press TIMER MENU.
2 Press M or m repeatedly until
“TIMER SEL?” appears,
then press ENTER.
3 Press M or m repeatedly until
“PLAY SELECT?” appears,
then press ENTER.
Change the setting Start over from step 1.
Cancel the timer
1 Press TIMER MENU.
2 Press M or m repeatedly until
“TIMER SEL?” appears,
then press ENTER.
3 Press M or m repeatedly until
“TIMER OFF?” appears,
then press ENTER.
Display
Turning off the display
— Power Saving Mode
Adjusting the brightness
of the display
To Next Page
Loading...
Need help?
General
