Getting Started
11
GB
Use buttons on the remote for the operation.
1 Press ?/1 to turn on the system.
2 Press TIMER MENU.
3 Press M or m repeatedly to set the hour.
4 Press ENTER.
5 Press M or m repeatedly to set the
minute.
6 Press ENTER.
The clock starts working.
To adjust the clock
1 Press TIMER MENU.
2 Press M or m to select “CLOCK SET?”, then
press ENTER.
3 Do the same procedures as step 3 to 6
above.
Notes
• The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.
• You cannot set the clock in Power Saving Mode
(page 49).
You can set the initial settings of “OSD”, “TV
TYPE” step by step.
After performing the Quick Setup, the system is
ready for playing back of movies, music CDs,
etc.
European model is used for illustration purposes
only.
1 Turn on your TV and select the video
input.
2 Press ?/1 to turn on the system.
3 Press FUNCTION + or – repeatedly (or
DVD on the unit) to switch the function
to DVD.
The guide message appears on the TV
screen.
Notes
• When a disc is in the system or the disc tray
opens, the guide message does not appear on the
TV screen. Remove the disc.
• When you press CLEAR, the guide message
disappears. When you need to perform the
Quick Setup, see “To recall the Quick Setup
display” (page 12).
4 Press ENTER.
“LANGUAGE SETUP” appears.
The language you select in “LANGUAGE
SETUP” is for “OSD”, “MENU” and
“SUBTITLE” (page 33).
5 Press M or m repeatedly to select a
language used in the on-screen
display.
The selectable language is different
depending on the area.
Setting the clock Performing the Quick
Setup
continued
To Next Page
Loading...
Need help?
General
