Specifications
AUDIO POWER SPECIFICATIONS
for the U.S. model
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
Inputs (Analog)
TV/vIDEO
(AUDIO
IN)
Sensitivity:
4501250
mV
AUDIO IN Sensitivity: 250/125 mV
Inputs (Digital)
TV/VIDEO (COAXIAL IN/OPTICAL IN)
Impedance: 75 ohms/-
Input Stream: Dolby
Digital 5.1ch/DTS 5.1ch/
Linear PCM 2ch
(Sampling Frequency: less
than 48 kHz)
VIDEO: 1 Vp-p 75 ohms
COMPONENT:
Y:
1 Vp-p
75
ohms
PB/CB,
PRlCR:
0.7
Vp-p
75
ohms
HDMI OUT: Type A (19
pin)
PLL quartz-locked digital
synthesizer
Antenna (aerial)
Intermediate frequency
Video Section
Outputs
Other models:
87.5 MHz - 108.0 MHz
(100 kHz step)
87.5 MHz - 108.0 MHz (50
kHz step)
Antenna (aerial) FM wire antenna (aerial)
Antenna (aerial) terminals
75
ohms, unbalanced
Intermediate frequency 10.7 MHz
AM tuner section
Tuning range
North American, Mexican, and Latin American
models:
530kHz-l,7IOkHz(with
the interval set at 10 kHz)
531
kHz - 1,710 kHz (with
the interval set at 9 kHz)
European, CIS, and Middle Eastern models:
531 kHz - 1,602 kHz (with
the interval set at
9 kHz)
Australian and New Zealand models:
531
kHz - 1,710 kHz (with
the interval set at
9 kHz)
530 kHz
-1,710
kHz (with
the interval set at 10 kHz)
531 kHz - 1,602 kHz (with
the interval set at
9 kHz)
530 kHz - 1,610 kHz (with
the interval set at
10
kHz)
AM loop antenna (aerial)
450 kHz
Other models:
FM tuner section
Tuning range
North American models:
Super Audio CD/DVD System
Laser Diode Properties Emission Duration:
Continuous
Laser Output: Less than
44.61"
W
* This output is the value measurement at a distance
of
200mm from the objective lens surface on the
Optical Pick-up Block with 7mm aperture.
Signal format system
North American models: NTSC
Other models: PALINTSC
Tuner Section
System
Accepts low- and high-
impedance headphones.
RMS
output power
FLJFRIC/SUSR*: 144watts
(per channel at 3 ohms, 1
kHz, 10% THD)
Subwoofer*: 280 watts (at
1.5 ohms, 80 Hz, 10%
THD)
With 3 ohms loads, both
channels driven, from 180
- 20,000 Hz; rated 84 watts
per channel minimum
RMS power, with no more
than 0.7% total harmonic
distortion from 250 milli
watts to rated output.
108 W
+ 108 W (at 3 ohms,
1 kHz, 1% THD)
RMS output power
FLIFRIC/SUSR*: 144 watts
(per channel at 3 ohms, 1
kHz, 10% THD)
Subwoofer*: 280 watts (at
1.5 ohms, 80 Hz, 10%
THD)
* Depending on the decoding mode settings and the
source, there may be no sound output.
Outputs (Analog)
Phones
Surround mode (reference)
Other models:
Stereo mode (rated)
Amplifier Section
U.S. models:
Surround mode (reference)
100
GB
To Next Page
Loading...
Need help?
General
