90
GB
Additional
Information
Precautions
On
power
sources
• Unplug the unit from the wall outlet (mains) if you do
not intend to use it for
an
extended period
of
time. To
disconnect the cord, pull
it
out
by
the plug, never by
the cord.
On
placement
• Place the system in a location with adequate
ventilation to prevent heat build-up
in
the system.
• At high volume, over long periods
of
time, the cabinet
becomes hot to the touch. This is not a malfunction.
However, touching the cabinetshould be avoided. Do
not place the system
in
a confined space where
ventilation is poor as this may cause overheating.
• Do not block the ventilation slots by putting anything
on the system. The system is equipped with a high
power amplifier.
If
the ventilation slots are blocked,
the system can overheat and malfunction.
• Do not place the system on surfaces (rugs, blankets,
etc.)
or
near materials (curtains, draperies) that may
block the ventilation slots.
• Do not install the system near heat sources such as
radiators, or air ducts,
or
in
a place subject to direct
sunlight, excessive dust, mechanical vibration, or
shock.
• Do not install the system in
an
inclined position. It is
designed to be operated in a horizontal position only.
• Keep the system and discs away from components
with strong magnets, such as microwave ovens, or
large loudspeakers.
• Do not place heavy objects on the system.
On
operation
• Ifthe system is brought directly from a cold to a warm
location, or is placed in a very damp room, moisture
may condense on the lenses inside the unit. Should
this occur, the system may not operate properly. In
this case, remove the disc and leave the system turned
on for about half an hour until the moisture
evaporates.
• When you move the system, take out any disc.
If
you
don't, the disc may be damaged.
•
If
anything falls into the cabinet, unplug the unit and
have
it
checked by qualified personnel before
operating
it
any further.
On
adjusting
volume
• Do not turn up the volume while listening to a section
with very low level inputs or no audio signals.
If
you
do, the speakers may be damaged when a peak level
section is suddenly played.
On
cleaning
• Clean the cabinet, panel, and controls with a softcloth
slightly moistened with a mild detergent solution.
Do
not use any type
of
abrasive pad, scouring powder
or
solvent such as alcohol
or
benzine.
If
you have any questions
or
problems concerning
your system, please consult your nearest Sony dealer.
On
cleaning
discs,
disc/lens
cleaners
• Do not use cleaning discs
or
disc/lens cleaners
(including wet
or
spray
types). These may cause
the
apparatus
to malfunction.
On
your
TV's
color
•
If
the speakers should cause the TV screen to have
color irregularity, turn
off
the TV then tum it on after
15
to 30 minutes.
If
color irregularity should persist,
place the speakers further away from the TV set.
IMPORTANT NOTICE
Caution: This system is capable
of
holding a still
video image
or
on-screen display image on your
television screen indefinitely.
If
you leave the still
video image
or
on-screen display image displayed
on your TV for an extended period
of
time you risk
permanent damage to your television screen.
Projection televisions are especially susceptible to
this.
On
moving
the
system
1 Press FUNCTION +1- repeatedly
to
select "DVD."
2 Make
sure
that
all
discs
are removed
from
the
unit.
3 Press t:> and IIC) simultaneously.
"MECHA
LOCK"
and "UNPLUG"
appear alternately in
the
front
panel
display.
4 Remove
the
AC
power
cord
(mains
lead)
from
the
wall
outlet
(mains).
To Next Page
Loading...
Need help?
General
