Sony DCR-IP5 Network Function User Manual

230
Adjusting the LCD screen (CALIBRATION)
The buttons on the touch panel may not work correctly. If this happens, follow the
procedure below.
(1) Set the POWER switch to OFF (CHG).
(2) Eject the cassette from your camcorder, then disconnect any connecting cable
from your camcorder.
(3) Set the POWER switch to VCR while pressing DISPLAY/TOUCH PANEL on
your camcorder, then keep pressing DISPLAY/TOUCH PANEL for about five
seconds.
(4) Follow the procedure below using an object such as the corner of a “Memory
Stick” supplied with your camcorder.
You can use the supplied stylus for this operation (DCR-TRV50 only).
1 Touch
at the upper left corner.
2 Touch
at the lower right corner.
3 Touch
in the middle of the screen.
Note
If you do not press the right spot, always returns to the position at the upper left
corner. In this case, start from step 4 again.
Maintenance information and precautions
CALIBRATE
CALIBRATE
CALIBRATE
FNINDEXPB

Sony DCR-IP5 Network Function Specifications

General

Brand	Sony
Model	DCR-IP5 Network Function
Category	Camcorder
Language	English