Sony DPS-D7 - Changing the Effects (EDIT)

Changing the
Effects (EDIT)
To
compare the result
with the former
effect
Press the
EDIT button.
This allows you to execute
comparative
listening in
the order
you
have
set
with the
“memory compare"
parameter of
the
Memory block. By
pressing the
EDIT button for the
second
time,
the former
parameter value will resume.
To change
other
parameters in the same
block
1 .
After changing the
parameter, press the
ENTER
button.
The parameter
selecting screen
will
be
displayed.
2
. Repeat steps 3 to
7 on the
previous page to
change
other parameters as
well.
To abort
the operation and
restore the
former
memory
setting
1
.
Press the
LOAD button.
Once the former
effect resumes,
all the
parameters you
have
been setting are
deleted, with the message
“Parameters
have been changed.
Are you sure
you want
to load?
Y-ENTER N-EDIT”.
If you accept
deletion of the
parameters
being changed,
press
the ENTER button.
Otherwise press
the EDIT
button to store the
effect you have
created by using
the
SAVE
function.
(See
page
30.)
2. Press
the ENTER button.
The former
memory resumes.
To
enter
the
date and user
information in the
System
block.
Press
the EDIT button to move
the cursor.
To change
other
parameters
in
other blocks
1
.
After
changing a
parameter,
press the
EDIT
button.
The
parameter
selecting
screen will be
displayed.
2.
Press the
EDIT button (or
press the
ENTER
button after
selecting
QUIT with the
dial).
The
block
selecting screen
will be
displayed.
3
. Repeat
steps 1
and 2 above
to do the
same for
other
parameters.
What is time
scale?
The time
scale is a
secondary
parameter
to change
the
“time”
parameters
of the
Delay block as a
whole.
This
is set to
100%
whenever you
select
“scale”. If at
least
one of the
“time”
parameters
reaches the
upper
limit
by
changing
the scale,
“over”
appears. Press
the ENTER
button after
changing this
parameter so
that each
“time”
parameter changes
at the
same ratio in
its scale.
(This
parameter will not
be stored.)
This
is typically used
to change
the
reflection
pattern with
respect to
the size
of
a
room
or the tempo
of music.
What is
“ch sync”?
The sync is a
secondary
parameter
for
making
different
parameter
values
per
channel
to
be the
same. The
parameter name
is followed by
“ch
sync”. If
chi, ch2 and
center are
given different
values,
executing “ch
sync” forces
them to
have the
same value.
Changing units
Normally the
System
block is used to
select a
unit.
However,
you
can also
change units
while
setting a
parameter by
pressing
the
ENTER and
HELP buttons
at the same
time.
OPERATION