143
Using your computer
1 Connect the camera and your
computer using the USB cable.
• Use the fully charged battery pack or the AC
Adaptor/charger (not supplied).
2 Turn on the camera and the
computer, then start the “Remote
Camera Control”.
3 Make settings on the control
panel, such as those for drive
mode, white balance, etc.
4 Adjust the focus and click the
(Shutter) button.
The camera shoots a subject and the
image is stored on the computer.
• For details on the operation, refer to the help of
“Remote Camera Control”.
Operating the camera from a
computer
USB cable
2 To the USB
terminal
1 To the USB
terminal
To Next Page
Loading...
