73
Using the shooting functions
Flash
This section explains the various shooting functions with the flash.
If the built-in flash is pulled up, the flash fires automatically when the surroundings are dark in
auto adjustment or Scene Selection mode. You can intentionally change the flash mode.
1 Press the Fn (Function) button to display the Quick Navi screen (page 30).
• When the enlarged display screen is used (page 23), you cannot display the Quick Navi screen. In this
case, set up from the menu.
2 Select a Flash item with the multi-selector.
3 Select the desired mode with the front or rear control dial.
• The flash indicator is displayed only when the flash is pulled up.
• After selecting the flash item in step 2, if you press the center of the multi-selector, the screen switches
to the Exclusive disp screen. On this screen, select the desired mode with v/V on the multi-selector, then
press the center.
• You can also select the flash mode from the Recording menu (page 99).
( : The default setting)
Selecting the flash mode
(Autoflash)
Fires if it is dark or against light.
• This is not selectable when the mode dial is set to P, A, S, or M.
(Fill-flash)
Fires whenever the built-in flash is pulled up.
Multi-selector
Fn (Function) button
Front control dial
Rear control dial
To Next Page
Loading...
