Chapter 5 Editing
90 Chapter 5 Editing
Setting Edit Points and Playback
Speeds
Perform the following procedure.
1 Press the ASSEMBLE or INSERT button to select
edit mode.
2 Press the PLAYER/DMC button together with the
ENTRY/SHIFT button.
The PLAYER/DMC indicator flashes and the unit
enters DMC edit mode.
When the playback speed is stored in memory, the
indicator flashes one time per second. When not, it
flashes four times per second.
To exit DMC edit mode
Press the PLAYER/DMC button together with the
DELETE button.
3 Press the RECORDER button.
The RECORDER indicator flashes.
4 To set edit points, press the ENTRY/SHIFT button
together with the IN or OUT button.
5 Press the PLAYER/DMC button and set the IN
point for the player.
Note
You cannot set an OUT point for the player.
6 Set the initial playback speed by rotating the
shuttle dial while holding down the PLAYER/
DMC button together with the ENTRY/SHIFT
button.
If you wish to set the initial speed to normal speed,
press the PLAY button.
The set speed is shown in the sub LCD.
7 Once the initial speed has been set, release the
PLAYER/DMC button and ENTRY/SHIFT
button.
8 Press the PREVIEW button.
The tape is prerolled. The recorder tape runs at
normal speed and the player tape runs at its initial
speed.
9 When the search button starts to flash, indicating
that the tape has reached the IN point, rotate the
shuttle dial to the position corresponding to the
desired playback speed.
The variations in playback speed are stored into
memory while the search button is flashing.
When the tape passes the OUT point, the search
button goes out.
If the JOG/SHUTTLE indicator goes out before
the tape passes the OUT point
The unit cannot store any more variations in playback
speed. The capacity of the playback speed memory is
120 seconds.
To amend the stored speed variation
Press the PREVIEW button.
The interval between the speed variation start and end
points is automatically played back at the stored speed.
Operate the search dial as required to adjust the
playback speed.
1
6,9
3
2,4,6,7
8
2,5,6,7
OFF
ON
TC
VITC
LOCAL
REC INHI
REMOTE
INT
EXT
MENU
TC TC SELECT
SET
AUDIO IN
VIDEO
CH1,1/2 CH2,3/4
AUDIO
TRIM
LIST MARK
CLIP
LINK
ENTRY SHIFT
IN OUT
ASSEMBLE INSERT
TC
– +
DELETE
EJECT REW PLAY F FWD
SERVO
CH-1/2
CH-3/4
PREROLL
REC SEQ EDIT
METER
REC
INHI
REVERSE
PLAYER
DMC
RECORDER
FORWARD
SHUTTLE
VAR
JOG
AUTO EDIT
AUDIO INPUT
PB
AUDIO
PREVIEW REVIEW
PRESET
VARIABLE
CH-1
PRESET
VARIABLE
CH-2 CH-3 CH-4
STOP
STANDBY
Z
m
B
M
x
z
DELETE
button
PLAY button
DMC Editing
To Next Page
Loading...
Need help?
General
