Sony EV-S350 - Page 42

3CH
4CH
fpe-22 $00.00 5, TDD OU DOOD DON Oe
POWER
42
CHANNEL
If you have a recorded video cassette tape |J-2
1 Set the RF UNIT channel selector located at the rear
of the VCR to 3CH or 4CH whichever channel is not
active in your area.
Press the POWER switch. The indication lights.
Insert the cassette.
Press the [> PLAY button.
Turn on the TV.
Set the TV receiver to either VHF channel 3 or 4 to
agree with the RF UNIT setting.
The TV program selected on the VCR will be
displayed on the TV screen. If a picture does not
appear on the TV screen or if the display is not
clear, fine-tune the channel on the TV.
e For details about TV channel adjustment, see the
instruction manual of the TV.
oO off W DN
Check!
Check that the display on the screen changes when
you stop the tape by pressing the 1 STOP button
on the VCR. (To eject the cassette, press the &
EJECT button.)
If the program does not change, repeat the preceding
steps.
Now your TV receiver is tuned to the VCR. Whenever
you use the video recorder, you should set the TV to
the channel which you have chosen above.