80 Troubleshooting
The VISCA control is not
available with a computer
connected to the camera.
The computer is not correctly
connected to the camera.
Make sure the connection
between the computer and
camera is made correctly.
Check that the baud rate setting
(9,600 bps or 38,400 bps) is
properly made with the
BOTTOM switch on the bottom
of the camera (page 57).
Check that the SYSTEM
SELECT switch (page 55) is set
to a position in which video
signals are output.
The camera cannot be
operated at all.
- Pull out the plug of the power
cord from the AC outlet, then
reinsert it into the AC outlet after
waiting a while.
Symptom Cause Remedy
To Next Page
Loading...
