Sony GTK-XB5 - Other Operations; Using the Party Chain function

GTK-XB5
18
2-15. SPEAKER UNIT (WF) (SP1, SP2)
:RRIHUFDEOHVHWWLQJ
:RRIHUFDEOHVHWWLQJ
3 terminal
(wide)
3 terminal
(narrow)
3 terminal
(wide)
3 terminal
(narrow)
4 speaker unit (WF)
(SP2)
4 speaker unit (WF)
(SP1)
2 Pull out the speaker unit (WF)
in the direction of the arrow.
terminal (wide)
terminal (narrow)
SP2
front side
terminal (wide)
terminal (narrow)
SP1
front side
,QVWDOODWLRQGLUHFWLRQIRUWKHVSHDNHUXQLW:)
Note 1:
When installing the speaker unit (WF), make sure
that there is a position of the speaker terminal to
the position shown in the figure below.
–)URQWYLHZ–
terminals
position
top side
SP2
SP1
Note 2:
When installing the woofer cable, make the
position of caulking of terminals is outside.
Note 2:
When installing the woofer cable, make the
position of caulking of terminals is outside.
left side
right side
speaker cabinet
top side
top side
bottom side
woofer cable
[yellow line]
woofer cable
[red line]
1 four screws
(M4 u 16)
1 four screws
(M4 u 16)