Sony GTK-XB5 - About the power management

GTK-XB5
9
2-5. NFC BOARD, CONTROL BOARD
filament tape
(sub material)
NFC board
CONTROL
board
2 connector
(XP11)
front side
rear side
top side
front side
front side
CONTROL board
))&FDEOH30$,1%')9%'VHWWLQJ
FFC cable
(16P MAIN BD-FV BD)
hole
hole
boss
6 connector
(XP8)
hole
5 Draw the FFC cable
(16P MAIN BD-FV BD)
out from the hole.
8 CONTROL board
7 FFC cable
(16P MAIN BD-FV BD)
This side is
the terminal side.
1
filament tape
(sub material)
top cover block
:LUHVHWWLQJ
boss
3 six screws
(M3 u 10)
4 CONTROL board block
Note 2:
When installing the CONTROL
board block, align the two bosses
and two holes.
–%RWWRPYLHZ–
5 NFC board
(See Note 1)
3 two
claws
4 Peel the NFC board off
of the adhesive sheet.
Disassembly of
the NFC board.
Disassembly of
the CONTROL board.
Note 1: When replacing the NFC board, be sure to replace the MAIN
board and the NFC board simultaneously. The NFC board
cannot replace with single. Among the repair parts, the MAIN
board and the NFC board are supplied as one unit.