when you want to turn the power of the HDD AUDIO PLAYER off but do not want to turn the
amplifier off.
If you operate the connected amplifier using the remote control supplied with the HDD
AUDIO PLAYER, operation of the amplifier may become inconsistent (operating at times but
not operating at other times) due to interference of the remote control signal, especially if you
continuously control the volume.
For example, if the infrared signal from the supplied remote control directly enters the remote
sensor (receiver) of the connected amplifier, interference may occur with the signal input
from the IR input jack of the amplifier or the signal output from the installed IR blaster. This
causes the amplifier to fail to receive the correct signal, resulting in inconsistent response
from the amplifier.
In this case, place the amplifier in a location where it will not be affected by the infrared
signal of the remote control of the HDD AUDIO PLAYER.
It is recommended that you use HDD Audio Remote, to avoid interference problems.
Operating an amplifier manufactured by another company
using the supplied remote control or a dedicated
application
If you register the remote control supplied with a connected amplifier manufactured by another
company to the HDD AUDIO PLAYER, you can perform operations such as turning on/off the
amplifier, adjusting the volume and muting the sound through the remote control supplied with
the HDD AUDIO PLAYER or the HDD Audio Remote application.
1. Select [Settings] - [Amp Control Settings] in the Home screen.
2. Confirm the description about the AMP Control Settings, and then select [Next].
The current settings are displayed.
Not learned: a function that has not been learned yet
In use: a function that has been learned and is to be used
Not in use: a function that has been learned but is not to be used
3. Select [Next].
A screen to select the manufacturer of the connected amplifier appears.
4. Select [Other].
5. Follow the instructions on the screen to connect the plug of the IR blaster (supplied) to the
IR REMOTE OUT jack of the HDD AUDIO PLAYER and place the other side of the IR
To Next Page
Loading...
