The power is automatically turned on.
If the [Network Standby] function is set to [On], the HDD AUDIO PLAYER is turned on when
it is operated through HDD Audio Remote or music files are transferred through HAP Music
Transfer.
The remote control does not work.
Point the remote control at the remote sensor on the HDD AUDIO PLAYER.
Remove any obstructions in between the remote control and the HDD AUDIO PLAYER.
Replace all the batteries in the remote control with new ones if they are low.
You cannot operate the connected Sony amplifier or an
amplifier from another manufacturer.
If you operate the connected amplifier using the remote control supplied with the HDD
AUDIO PLAYER, operation of the amplifier may become inconsistent (operating at times but
not operating at other times) due to interference of the remote control signal, especially if you
continuously control the volume.
For example, if the infrared signal from the supplied remote control directly enters the remote
sensor (receiver) of the connected amplifier, interference may occur with the signal input
from the IR input jack of the amplifier or the signal output from the installed IR blaster. This
causes the amplifier to fail to receive the correct signal, resulting in inconsistent response
from the amplifier.
In this case, place the amplifier in a location where it will not be affected by the infrared
signal of the remote control of the HDD AUDIO PLAYER.
It is recommended that you use HDD Audio Remote, to avoid interference problems.
Even if you configure the remote control supplied with the HDD AUDIO PLAYER so that it
can operate equipment manufactured by other companies, the remote control may not work
correctly depending on the manufacturer or manufacture year of the equipment.
To Next Page
Loading...
