This function is useful in the following cases:
When music files are transferred to the HDD AUDIO PLAYER using the HAP Music Transfer
application.
When you want to launch the HDD AUDIO PLAYER from the HDD Audio Remote
application.
Select [Settings] - [System Settings] - [Network Standby] from the menu to set the Network
Standby mode.
Note
The HDD AUDIO PLAYER does not enter standby mode when music files are being
transferred from your computer, smartphone or tablet or when the HDD AUDIO PLAYER is
analyzing transferred music files, even if you press the button to switch to standby mode.
The HDD AUDIO PLAYER enters standby after all target music files are transferred and
analyzed.
Hint
The HDD AUDIO PLAYER enters the Network Standby mode after 20 minutes of no
operations and no playback if [Auto Standby] is set to [On] (factory default setting).
[86] Dealing with problems/Inquiries
Forced shutdown of the HDD AUDIO PLAYER
In the rare case of an unusual situation, such as if the HDD AUDIO PLAYER does not respond
to operations of the buttons and controls, you can forcibly turn the power off.
You do not need to forcibly shut down the HDD AUDIO PLAYER in normal use.
1. Press and hold on the HDD AUDIO PLAYER for 5 seconds or more.
The power lamp flashes three times and then the power turns off.
After a while, the HDD AUDIO PLAYER is automatically rebooted and enters the standby
mode or the Network Standby mode.
Note
If you forcibly shut down the HDD AUDIO PLAYER while music files are being transferred,
the files or setting configurations may not be saved in or applied to the HDD AUDIO
PLAYER.
To Next Page
Loading...
