19
HCD-BX5BT/CBX1/CBX3
CD POWER MANAGE
This mode is used to changed over CD power on/off for decreasing
of reception noise in the tuner mode.
Procedure:
1. Press the I/1 button to turn the power on.
2. Press the [FUNCTION] button to select “CD” (BX5BT/CBX1).
Press the [CD] button on the remote commander to select “CD”
(CBX3).
3. Press the I/1 button again to turn the power off.
4. Press two buttons of [ /CANCEL] and I/1 simultaneously.
5. The message “CD POWER ON” or “CD POWER OFF”is
displayed on the liquid crystal display, and CD power on/off
is changed over in the tuner mode.
CD SERVICE MODE
This mode can run the CD sled motor freely. Use this mode, for
instance, when cleaning the optical pick-up.
Procedure:
1. Press the I/1 button to turn the power on.
2. Press the [FUNCTION] button to select “CD” (BX5BT/CBX1).
Press the [CD] button on the remote commander to select “CD”
(CBX3).
3. Press three buttons of [ /CANCEL], [CD ] and Z simul-
taneously, the message “SERVICE M” is displayed on the liq-
uid crystal display.
4. Press the [TUNE ---] button to move the optical pick-up to inside
track and the message “SLED IN” is displayed on the liquid
crystal display, or press the [TUNE +] button to outside track
and the message “SLED OUT” is displayed on the liquid
crystal display.
5. Press the [CD ] button, “LD ON” or “LD OFF” is dis-
played on the liquid crystal display. Each time [CD ]
button is pressed, laser diode on/off is changed over.
6. To release this mode, press the
I/1 button.
BT TEST MODE
(BX5BT)
This mode is used to check the firmware version and address of
bluetooth module.
Procedure:
1. Press the I/1 button to turn the power on.
2. Press the [FUNCTION] button to select “BLUETOOTH”.
3. Press three buttons of [DSGX], [BLUTOOTH ] and [BLU-
TOOTH OPR] simultaneously, the message “BT Test” is dis-
played on the liquid crystal display. Then, the display is au-
tomatically changed to the firmware version of bluetooth
module.
4. Press the [DISPLAY] button, address of bluetooth module is
displayed on the liquid crystal display.
5. To release this mode, press the I/1 button.
x
x
u
u
u
u
To Next Page
Loading...
