Sony HT-A9 User Manual

3
US
C:\HT2020\AC\Data\UC2\5025229111\5025229111HTA9UC2\01GB-HTA9UC2\020REG.fm
masterpage: Right
HT-A9
5-025-229-11(1)
in a residential installation. This speaker
system generates, uses and can radiate
radio frequency energy and, if not
installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this speaker system does
cause harmful interference to radio or
television reception, which can be
determined by turning the speaker
system off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
– Reorient or relocate the receiving
antenna.
– Increase the separation between the
speaker system and receiver.
– Connect the speaker system into an
outlet on a circuit different from that
to which the receiver is connected.
– Consult the dealer or an experienced
radio/TV technician for help.
Properly shielded and grounded cables
and connectors must be used for
connection to host computers and/or
peripherals in order to meet FCC
emission limits.
If you have any questions about this
speaker system:
Visit: https://www.sony.com/
electronics/support
Contact: Sony Customer Information
Service Center at 1-800-222-SONY (7669)
Write: Sony Customer Information
Service Center 12451 Gateway Blvd., Fort
Myers, FL 33913
Supplier’s Declaration of Conformity
Trade Name: SONY
Model No.: HT-A9
Responsible Party: Sony Electronics Inc.
Address: 16535 Via Esprillo, San Diego,
CA 92127 USA
Telephone No.: 858-942-2230
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
CAUTION
You are cautioned that any changes or
modifications not expressly approved in
this manual could void your authority to
operate this speaker system.
This speaker system must not be co-
located or operated in conjunction with
any other antenna or transmitter.
This speaker system complies with FCC
radiation exposure limits set forth for an
uncontrolled environment and meets
the FCC radio frequency (RF) Exposure
Guidelines. This speaker system should
be installed and operated keeping the
radiator at least 20 cm or more away
from person’s body.
Compliance with FCC requirement
15.407(c) and IC requirement RSS-247
Data transmission is always initiated by
software, which is the passed down
through the MAC, through the digital
and analog baseband, and finally to the
RF chip. Several special packets are
initiated by the MAC. These are the only
ways the digital baseband portion will
turn on the RF transmitter, which it then
turns off at the end of the packet.
Therefore, the transmitter will be on only
while one of the aforementioned
packets is being transmitted. In other
words, this device automatically
discontinue transmission in case of
either absence of information to
transmit or operational failure.
Frequency Tolerance: ±20 ppm or less
010COV.book Page 3 Wednesday, November 25, 2020 3:33 PM

Sony HT-A9 Specifications

General

Tweeter	Yes
Speaker type	Full range
Number of drivers	-
Speaker placement	Floor, Tabletop/bookshelf
Audio output channels	- channels
Number of tweeter drivers	2
Audio decoders	DTS, DTS-ES, DTS-HD HR, DTS-HD Master Audio, Dolby Atmos, Dolby Digital, Dolby Digital Plus, Dolby Dual Mono, Dolby TrueHD
RMS rated power	504 W
Bluetooth version	5.0
USB connector type	USB Type-A
USB 2.0 ports quantity	1
Connectivity technology	Wireless
Product color	Gray
Recommended usage	Home
Cables included	AC, HDMI
Quantity per pack	4 pc(s)
Package type	Box
Package depth	213 mm
Package width	725 mm
Package height	468 mm
Package weight	16000 g

Weight and Dimensions

Depth	147 mm
Width	160 mm
Height	313 mm