Sony HT-DDW790 - Page 60

Specifications
AUDIO POWER
SPECIFICATIONS
(HT-DDW790 only)
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(Models of area code U only)
With 6 ohm loads, both channels driven, from
120 20,000 Hz; rated 85 watts per channel
minimum RMS power, with no more than 1%
total harmonic distortion from 250 milliwatts
to rated output.
Amplifier section
HT-DDW790 only
Models of :u'ea code U, CA, CEL, CEK
Power Outpul 1)
Stereo mode (rated)(6 olnus 1kHz, THD 1%)
85W+85W
Surround mode2) (relerence)
(6 ohms I kHz, THD 10%)
RMS nutput
FRONT: 133 W
per channel
CENTER: 133 W
SURROUND: 133W
per channel
Surround mode2) (relerence)
(6 ohms 100Hz, THD 10%)
SUB WOOFER: 135W
HT-DDW685 only
Models of area code SP, MX, E51
Power Oulpu! 1)
Stereo mnde Crated) (6 ohms I kHz, THD 1%)
70 W + 70 W
Surround mode 2) (relerence)
(6 ohms 1 kHz, THD 1()(7_)
RMS output
FRONT: 100 W
per channel
(ENTER: 100 W
SURROUND: 100 W
per channel
Surround mode 2) (reli_rence)
( 10 ohms 100 Hz, THD 10%)
SUB WOOFER: 60 W
per channel
Models of area code AR
Power Oulput 1)3 )
Stereo mode (rated) (6 ohms 1kHz, THD I(7_)
70 W + 70 W I)
65 W + 65 W 3)
Surround mode2) (relerence)
(6 ohms 1 kHz, THD 10%)
RMS output
FRONT:
100 W per channel 1)
90 W per channel3)
CENTER:
100 W 1)
90 W3)
SURROUND:
100 W per channel 1)
90 W per channel3)
Surround mode2) (relerence)
( 10 ohms 100Hz, THD 10%)
SUB WOOFER:
60 W per channel I)
50 W per channel3)
1)Measured under the following conditions:
Area code Power requirements
U, CA 120 V AC, 60 Hz
CEL, CEK, SP, AR 230 V AC, 5(1Hz
E51 240 V AC, 50 Hz
MX 127 V AC, 60 Hz
60 G8