To create an index name
1 Use l./.!./<,t,_ to create an index name.
Press tl./4 to select a character, then press
<,/* to move the cursor to the next position.
If you made a mistake
Press <,/* until tile character you want to
change flashes, then press l./!l, to select the
correct character.
Tip
You c;m select the character type as lollows by
pressing ll!.
Alphabet (upper case) i+ Numbers i+ Symbols
2 Press @.
The entered name is registered.
Note (Models of area code CEL, CEK
only)
_Vheu _o/1 nalne all RDS station and tnue ill that
station, the Program Service name appears instead
of the name you entered. (You cannot change the
Program Service name. The name you entered will
be overwritten by the Program Service name.)
UsingtheRadioData
System(RDS)
(Models of area code CEL, CEK
only)
This recei,,er also allows you to use RDS
(Radio Data System), which enables radio
stations to send additional information along
with the regular program signal. You can
display RDS information.
Notes
• RDS is operable onl> lbr FM static)us.
• Not all FM stations provide RDS service, nor do
they provide the same type of services. If you are
not familiar with the RDS services in your area.
check with your local radio stations lot details.
Simply select a station on the FM
band using direct tuning (page 47),
automatic tuning (page 46), or
preset tuning (page 49).
When you tune ill a station that prox.ides RDS
services, "RDS" lights up and the program
service name appears on the display.
Note
RDS may not "_xork properly il tile station you tuned
to is not transmitting the RDS signal properly or if
the signal strength is weak.
50 G8
To Next Page
Loading...
