Self-diagnosis Code
Symptom/State Correction
E 6 2 1 2 Shift lens overheating (YAW) Check signal line connections from CPU through steady-
shot IC to PITCH/YAW drive.
When there is no problem with the connections, check
whether this error is due to the lens or the board. Replace
the faulty lens or board.
E 6 2 2 0 Abnormality of thermistor Check signal line connections from CPU through steady-
shot IC to PITCH/YAW drive.
When there is no problem with the connections, check
whether this error is due to the lens or the board. Replace
the faulty lens or board.
E 6 2 3 0 Abnormal CPU Turn power off and turn power on again. When this error is
not cleared, replace the board that mounts the CPU.
E 9 1
0 1
*1
Abnormality when flash is being
charged
Check or replace the LED flash/video light or charging ca-
pacitor.
E 9 1
0 2
*1
Abnormality of LED video light Check or replace the LED flash/video light or charging ca-
pacitor.
E 9 1
0 3
*1
Abnormality of LED video light
Temperature detection
Check or replace the LED flash/video light or charging ca-
pacitor.
E 9 2 0 0 Battery/Dry cell distinction defect Turn power off and turn power on again.
E 9 2 0 1 Battery current value goes over the
max discharge current
Confirm whether or not the symptom is occurred after re-
placing the battery. If the symptom is still occurred, replace
board.
E 9 4
0 0
*1
Fault of writing or erasing the inter-
nal memory
Turn power off and turn power on again.
E 9 4
0 1
*1
Abnormality of the internal memory Turn power off and turn power on again.
E 9 4 0 2 BGM data error The CPU may be faulty.
Replace the board that contains this peripheral circuit.
E 9 5
0 0
*1
GPS hardware error Check the signal line connection for GPS.
When there is no problem with the connections, replace the
board that contains this peripheral circuit.
E 9 5
0 1
*1
Acceleration sensor hardware error The acceleration sensor may be faulty.
Replace the board that contains this peripheral circuit.
E 9 5
0 2
*1
Electronic compass hardware error
(GPS hardware error)
The peripheral circuit of the electronic compass may be
faulty.
Replace the board that contains this peripheral circuit.
E 9 6
0 0
*1
Map area mount error The flash memory may be faulty.
Replace the board that contains this peripheral circuit.
E 9 7
0 0
*1
Projector hardware error The peripheral circuit of the projector may be faulty.
Replace the board that contains this peripheral circuit.
*1: Function of this code is not provided in this unit.
HXR-NX80/HXR-MC88
2-4
To Next Page
Loading...
Need help?
General
Weight and Dimensions
