11
ICF-CD855V
CD TEST MODE
Procedure:
1. Connect 22 kΩ and 100 kΩ resistors in parallel to the end of S618 on the LCD board, and short another end of resistors to the GND,
and the CD TEST MODE will be activated.
2. Insert a CD disc.
3. Turn the power on. Press the CD u button.
4. The following shows the state transition table for each button operation in respective sub modes of CD TEST MODE.
State Transition Table
If each button is pressed in respective sub modes, the mode will transit to the sub modes listed in table.
Mode transits to sub modes listed in table, if a button is pressed in respective sub modes.
5. Turn the power off to release the CD TEST MODE.
MODE Explanation LCD Button
MAIN SUB
OFF CD –+ RADIO ON SLEEP –+ Processing
BAND end
Long pressed
INT State when TEST MODE is activated.
0STOP0 FOCUS0
STOP STOP0 State when a button is pressed once from initial state.
1 FOCUS0 SLDF
SLDF
SLDR
SLDR
EF
ADJ1:11
Normal
STOP0 Automatically adjusted value is held.
2STOP0 FOCUS0 Normal
FOCUS FOCUS0 AUTO FOCUS transfer mode
3STOP FOCUS
FOCUS FOCUS SERVO ON state.(CLV-S, TRK/SLED, SERVO OFF)
4STOPF.LPC EF AUTO
It will be referred to as LPC ON if FOCUS carries out on.
OFF ADJ2:11
F.LPC OFF LPC OFF in FOCUS state.
5STOP ALSV FCSF
FCSF
FCSR
FCSR
SCURVE
ALL ALSV State where all servo systems are turned on.
7STOP LPC OFF FCSF FCSR EF
ADJ3:11
AUTO
SERVO
ALPC OFF State where all servo systems are turned on.(LPC:OFF)
8STOP TGUP FCSF FCSR
TGUP State with TRK GAIN UP in all servo systems are turned on.(LPC:ON)
9STOP ALSV FCSF FCSR
AUTO Mode in which automatic adjustment is made at once.
b
SLED SLDF SLED is fed outward in STOP state.
cSTOPSTOPSTOPSTOPSTOP SLDF
SLDR SLED is fed inward in STOP state.
dSTOPSTOPSTOPSTOP SLDR
F.SLED FCSF SLED is fed outward in FOCUS state.
E FOCUS FOCUS FOCUS FOCUS FOCUS FCSF
FCSR SLED is fed inward in FOCUS state.
F FOCUS FOCUS
STOP
FOCUS FOCUS FOCUS FCDR
.
>
.
>
u
x
To Next Page
Loading...
