Note
You can save up to 10 settings per memory card. When 10 settings have been already saved, you cannot perform [Save New].
Delete the existing settings using [Delete], or overwrite them.
Only Slot 1 is used for saving or loading data. You cannot change the saving/loading destination slot.
You cannot load settings from a camera of a different model.
You can use this function to save settings registered to [
Camera Set. Memory]. However, [Save/Load Settings] is
unavailable when the mode dial is set to 1/2/3 (
Recall Camera Setting). Set the mode dial to a position other than 1/2/3
before using this function.
5-044-866-11(1)
Copyright 2022 Sony Corporation
To Next Page
Loading...
