If the power lamp is lit up in red even though the ON/OFF (power) switch is turned on, the following conditions are possible.
Check the following settings and the power supply state, etc. as necessary.
The power off setting was executed by an application developed with the Camera Remote SDK.
The power save function was activated.
The input power supply voltage is less than 10 V.
The input power supply voltage is more than 18 V.
The temperature of the camera rose, and the power was turned off to protect the product.
If you cannot start the camera even though there are no problems with the settings or the power supply state, consult the service
facility.
Related Topic
Power & Control terminal specifications
Constructing a Power & Control Cable by hand
TP1001273576
5-055-988-11(1) Copyright 2023 Sony Corporation
To Next Page
Loading...
