Getting Started
11
GB
Inserting two R6 (size AA)
batteries into the remote
Operating a Sony TV
You can use the following buttons on the remote
to operate a Sony TV.
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
Tip
With normal use, the batteries should last for about six
months. When the remote no longer operates the
system, replace both batteries with new ones.
Attaching the speaker pads
Attach the supplied speaker pads to the bottom
of the speakers to stabilize the speakers and
prevent them from slipping.
Front speaker (Left (4)/Right (4))
Center speaker* (2)
Speaker pads are not supplied for the surround
speakers.
* MHC-RV990D only
To Press
Turn the TV on or off TV ?/1
Switch the TV’s input
source between the TV and
other input sources
TV/VIDEO
Change the TV channels TV CH +/–
Adjust the volume of the
TV speaker(s)
TV VOL +/–
E
e
E
e
When carrying this system
Perform the following procedure to protect
the DVD mechanism.
1 Press ?/1 to turn on the system, then
press DVD. Make sure that all discs are
removed from the system.
2 Hold down DVD, then press ?/1 until
“STANDBY” appears.
When “STANDBY” disappears, “LOCK”
appears.
3 Unplug the power cord.
To Next Page
Loading...
Need help?
General
