52
GB
Other operations
Notes
• You cannot activate the Daily Timer and Timer
recording at the same time.
• If you use the Timer recording, the Daily Timer and
the Sleep Timer at the same time, the Sleep Timer
has priority.
• If the system is on at the preset time, the Timer
recording will not be activated.
• The volume is reduced to minimum during
recording.
• Do not operate the system from the time the system
turns on until the recording starts (about 15 seconds
before the preset time).
• Note that if the Timer Recording is set at the same
time as the Daily Timer sound source is set to tape,
the Timer Recording sound may be recorded onto the
tape.
The demonstration display (display window and
buttons lighting and flashing even when the
system power is off) and the clock display can
be turned off to minimize the amount of power
consumed during standby (Power Saving
Mode).
Press DISPLAY repeatedly while the
system is off until the demonstration
display or the clock display disappears.
To cancel Power Saving Mode
Press DISPLAY while the system is off. Each
time you press the button, the display switches
cyclically as follows:
Demonstration display t Clock display* t
No display (Power Saving Mode)
* The clock is displayed only if you set the clock.
Note
You cannot perform the following operations in Power
Saving Mode.
– setting the clock
– changing the AM tuning interval (except for Saudi
Arabian models)
– turning on the system by pressing the function
buttons
– switching the MD (VIDEO) function
– changing the color system
Tips
• The timer continues to operate in Power Saving
Mode.
•
?/1 indicator lights up even in the Power Saving
Mode.
To Do this
Check the setting 1 Press CLOCK/TIMER
SELECT.
2 Press M or m repeatedly
until “REC SELECT”
appears, then press ENTER.
Change the setting Start over from step 1.
Cancel the timer
1 Press CLOCK/TIMER
SELECT.
2 Press M or m repeatedly
until “TIMER OFF” appears,
then press ENTER.
Display
Turning off the display
— Power Saving Mode
To Next Page
Loading...
Need help?
General
