11
To start/stop recording in
sync with the source player
(Synchro-recording)
You can easily make digital recordings of
a digital source on an MD.
Before synchro-recording, make
connections to the digital source with a
digital cable, and insert a recordable MD.
Recording with digital
input (optical cable
required)
Connect to a digital source using the
supplied optical cable, or POC-5B or
POC-5AB (not supplied) to make digital
recordings. Digital recording is possible
even from digital equipment with
different sampling rates, such as a DAT
deck or a BS tuner, using the built-in
sampling rate converter.
SYNCHRO REC (at the bottom)
Portable CD
player, etc.
Optical
mini-
plug
Optical
plug
CD player, MD
player, digital
amplifier, etc.
to
(OPTICAL)
LINE IN
POC-5B
(not supplied)
etc.
Optical
connecting cord
(supplied) etc.
CD players,
etc.
continued
p•CHARGE
(OPTICAL) LINE IN jack is for both
digital and analog input
The recorder automatically recognizes the
type of line cable and switches to digital or
analog input.
To stop recording, press p.
Notes
•You can make a digital recording only from an
optical type output.
•When recording from a portable CD player,
play it on AC power and disable the anti-skip
function (such as ESP*).
•Digital output may be disabled on some
portable CD players when the player is not run
on AC power.
* Electronic Shock Protection
1 Insert a recordable MD and start
recording.
For recording operations, see
“Recording an MD right away !”
(page 6). To record from a portable
CD player, set the CD player to pause
and then start recording.
To Next Page
Loading...
