HD Visual Communication System PCS-XL55
Quick Connection Guide
1. To begin with 2. Let’s connect
Main indicators that appear during communication
2
Enter the IP address or ISDN line
number of a remote party.
Select “Dial” and press ENTER, or
press
.
3
Select the Line I/F.*
1
* The Line I/F cannot be
selected depending on
the system setup.
Press ENTER after each selection to proceed.
For details on operations, refer to the Operating Instructions (stored in the supplied CD-ROM).
Turn on your HD Visual Communication System and TV
monitor, and check the following to ensure that connection is
possible.
The system is equipped with a lens cover to hide the camera.
Before starting a videoconference, open the lens cover by
sliding the lever for lens cover on the top of the system to the
right. If the lens cover is closed, the picture on the local site
will not be seen on the remote site.
The number is dialed, and the
system establishes connection.
1 2 3
Notes:
Connection to a remote party is not possible if neither
the IP address nor ISDN line number is not displayed.
You can hide the IP address of the local system using
the setup menu.
Presentation (reception) is
being executed.
Local party has drawing rights for
annotation (function for writing on
the display via a pen tablet).
Controlling a remote camera.
Local microphone is turned off.
Presentation (transmission) is
being executed.
Is the picture of your camera (local picture) on the
monitor screen?
Is the IP address of the local system or the
ISDN line number displayed?
Lever for
lens cover
Camera
Note:
To use the direct dialing function, the
[Direct Dial] setting must be set to
[On] in the Home Menu setup menu.
This section describes how to
make a call via direct dialing.
4-270-135- 12 (1)
© 2010 Sony Corporation
To Next Page
Need help?
General
