19
3-2 Connections and Settings
Chapter 3 Preparations
3-2 Connections and Settings
3-2-1 Connecting to a Computer
By connecting this unit to a computer, you can use the utility
software, and the other supplied software.
• The XDCAM Drive Software (see page 18) must be installed in
advance.
• To disconnect the PDW-U1 from a Windows computer, run the
“Safely Remove Hardware” dialog, and then disconnect the cable.
Example connection
Notes
1
PDW-U1
USB
DC IN 12V
1: USB cable
To USB connector
Laptop computer
To Next Page
Loading...
