PRS-950
8
2-9. CARD ASSY (FOX MINIATURE) (WW1)
Note: When the WWAN antenna cable is removed, refer to “Wi-Fi OPERATION CHECK” (page 3).
2-10. WWAN ANTENNA (ANT1)
Note 1: When the WWAN antenna is removed, refer to “Wi-Fi OPERATION CHECK” (page 3).
1 two new truster screws
(M2)
3 WWAN antenna cable
4 card assy (fox miniature)
(WW1)
2
– Rear side view (bottom side) –
4 Peel the adhesive.
– Rear side view (bottom side) –
2 WWAN antenna cable
5 WWAN antenna
(ANT1)
1 sheet (antenna)
Note 3:
When pasting sheet (antenna), please let me
stick to MAIN board rubbing on several times.
3 Peel the aluminum tape.
Note 4:
When pasting aluminum
tape, please let me stick to
MAIN board rubbing on
several times.
3 Peel the aluminum tape.
Note 4:
When pasting aluminum tape, please let me
stick to MAIN board rubbing on several times.
chassis
WWAN antenna
MAIN board
1 + 1 (-0) mm 1 + 1 (-0) mm
mounted parts mounted parts
sheet (antenna)
:ire SroFessiQJ
WWAN antenna cable
Note 2:
Please take care not to run aground in the chassis.
To Next Page
