Sony PS-Q7 - SPECIFICATIONS

SPECIFICATIONS
Turntable
Platter
Motor
Drive system
Control system
Speed
Wow and flutter
Signal-to-noise ratio
Automatic system
Tonearm
Type
Cartridge
Type
Frequency response
Channel separation
Load impedance
Tracking force
Stylus
Weight
Amplifier section
Outputs
Frequency response
General
Power requirements
Power consumption
Dimensions
Weight
Supplied accessory
10
7.8.cm (34s in.), aluminum-alloy diecast
Linear torque BSL (brushless and slotless)
motor
Direct drive
Magnedisc servo control system
3343 rpm, 45 rpm
0.08% (WRMS) *
68 dB (DIN-B)
Lead-in, return, reject
Dynamic balanced
low mass type
Moving magnet type
10 to 20,000 Hz
20 dB at 1 kHz
50 kiiohms
29
Sony ND-143G (0.6 mil diamond)
3.4g
PHONO OUT
Stereo minijack
HEADPHONES
Stereo minijack
—60 dB to -23 dB (at 8 ohms load)
RIAA equalization curve +0.5 dB
Type 1: 220V ac
Type 2: 240Vac
Tyep 3: 110 - 120 or 220 ~ 240 V ac
adjustable
50/60 Hz
5 W
Approx. 215 x 235 x 58 mm (w/h/d)
(84/2 x 93/8 x 23/8 in.)
including projecting parts and controls
Approx. 2.5 kg (5 Ibs 8 02) net
Approx. 3.2 kg (7 lbs 8 02), in shipping
carton
45-rpm adaptor (1)
Connecting cord (1)
While the information given is correct at the time of printing, small
production changes in the course of our company’s policy of im-
provement through research and design might not necessarily be
indicated in the specifications. We would ask you to check with
your appointed Sony dealer if clarification on any point is required.
Note
Appliance conforms with EEC Directive 76/889 regarding inter-
ference suppression.
* This new measuring method concerns only the turntable assembly, in-
cluding the platter. It excludes wow and flutter caused by the tonearm, the
cartridge, or the record. Measured by obtaining signal from magnetic pick-up
head.